Prescolite 1475 - Manual (Page 2)

www
.prescolite.com
• Prescolite
TollFree
Technical Support
1.888.PRS.4TEC
• Hours: 8am - 5pm ET
101 Corporate Drive • Spartanburg, SC 29303
With representatives offices in principal cities throughout North America.
Copyright 2005, 08/05 revision, All Rights Reserved - Printed in U.S.A.
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .05588200
Instruction
Sheet
CAUTION: Do not attempt to modify or rewire factory-installed wiring on the fixture. Safety and proper operation of the fixture depend
on the integrity of the wiring.
4. Remove J-Box cover plate. Remove appropriate knockout and assemble appropriate con-
nector for the supply wire used. Connect ground wires to green ground leads. Connect
white (common) to white (leads). Connect power supply (line) to black lead(s). Reinstall J-
Box cover.
WARNING: DO NOT pinch wires between J-Box/ballast cover and J-Box. Consult a
Qualified Electrician for all other options that require other wiring configurations. If
fusing is required, a field-installed module is available (module is cartoned
separately).
5. Aiming the lamp.
A. For horizontal aiming, loosen the thumb screw securing the horizontal rotation lock.
Grasp the yoke and rotate (360° max.) about center of fixture until proper aiming is
achieved. Tighten the thumb screw to lock the rotation pan in place.
B. For vertical aiming, loosen the (2) wing nuts securing the yoke to the trim retaining
brackets. Grasp the yoke and push or pull to desired position. Tighten the wing nuts
to ensure that desired adjustment is maintained during re-lamping.
Note: Yoke adjusts from vertical to 45° in one direction only.
6. Install proper lamp and trim.