Prescolite 1375 - Manual

Instruction
Sheet
www
.prescolite.com
• Prescolite
TollFree
Technical Support
1.888.PRS.4TEC
• Hours: 8am - 5pm ET
101 Corporate Drive • Spartanburg, SC 29303
With representatives offices in principal cities throughout North America.
Copyright 2005, 08/05 revision, All Rights Reserved - Printed in U.S.A.
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .05282500
Instruction
Sheet
INSTALLATION INSTRUCTIONS
CAT NO. 1371 & 1375
Housing
Pivot Adjustment
Ring
Trim Retaining Clip (3)
Housing Clip
J-Box
Lamp
(by others)
Adjustment
Screw (2)
Transformer
(277/120 Volt
version only)
Thermal Protector
Adjustable
Bar Hanger
Rotation/Pivot
Yoke
CAUTION: To avoid electrical shock, be sure power supply is turned off before installing or servicing this fixture.
WARNING - RISK OF FIRE:
Do not install insulation within three (3) inches of fixtures sides, wiring compartment or top of fixture
in such a manner to entrap heat.
1. Refer to instruction sheet No. 463 (included) to assemble the bar hangers, install
and adjust the housing.
2. Adjust the fixture so the bottom edge of the plaster flange is flush with the finished
ceiling line. Accomplish this using the adjustable screws securing the mounting
brackets on either end of the fixture.
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information
and instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials,
and proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and
during servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed by
qualified service personnel. Product must be grounded to avoid potential electric shock or other potential hazard.
Product must be mounted in locations and at heights and in a manner consistent with its intended use, and in
compliance with the National Electrical Code and local codes. The use of accessory equipment not recommended by
the manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from
product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens or
the like to come into contact with the product or to block light from the product, as this may cause an unsafe condition.