Prescolite 79 SERIES - Manual

Instruction
Sheet
www
.prescolite.com
•
Prescolite
T
ollFree
T
echnical
Support
1.888.PRS.4TEC
•
Hours:
8am
-
5pm
ET
101 Corporate Drive, Suite L • Spartanburg, SC 29303
With representatives offices in principal cities throughout North America.
Copyright 2004, 08/04 revision, All Rights Reserved - Printed in U.S.A.
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .06268800
Instruction
Sheet
INSTALLATION INSTRUCTIONS
79 SERIES
Housing
Adjustable Socket Bracket
Plaster Flange
1. Install the fixture in the ceiling using mounting channel, bar stock or 1/2" rigid conduit placed in the adjustable
mounting brackets. The fixture should be installed in such a manner that the weight of the fixture is supported by
the mounting channels/bar stock/rigid conduit and/or hanger wires secured to the building structure.
2. Adjust the fixture so the bottom edge of the plaster flange is flush with the ceiling.
3. Secure the ballast to the fixture with the supplied ballast strap.
4. Remove the J-Box cover(s). Determine where the supply conduit will enter the J-Box.
5. Wire the fixture by following the diagrams on the back of this page. Be sure to connect green ground wire and push
the splices into the J-Box. Replace the J-Box cover(s).
Ballast Strap
J-Box Covers
Wing Nut
Adjustable
Mounting Bracket (2)
Ballast
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information
and instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials,
and proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and
during servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed by
qualified service personnel. Product must be grounded to avoid potential electric shock or other potential hazard.
Product must be mounted in locations and at heights and in a manner consistent with its intended use, and in
compliance with the National Electrical Code and local codes. The use of accessory equipment not recommended by
the manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from
product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens or
the like to come into contact with the product or to block light from the product, as this may cause an unsafe condition.