Prescolite 4M1 - Manual

INSTALLATION INSTRUCTIONS
4M1 TRIM
Instruction
Sheet
www
.prescolite.com
• Prescolite
TollFree
Technical Support
1.888.PRS.4TEC
• Hours: 8am - 5pm ET
101 Corporate Drive • Spartanburg, SC 29303
With representatives offices in principal cities throughout North America.
Copyright 2006, 01/06 revision, All Rights Reserved - Printed in U.S.A.
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .93005309
Instruction
Sheet
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information
and instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials,
and proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and
during servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed by
qualified service personnel. Product must be grounded to avoid potential electric shock or other potential hazard.
Product must be mounted in locations and at heights and in a manner consistent with its intended use, and in
compliance with the National Electrical Code and local building codes. The use of accessory equipment not
recommended by the manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light
emanating from product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes,
curtains, screens or the like to come into contact with the product or to block light from the product, as this may cause an
unsafe condition.
A. Trim Installation:
1. Loosen horizontal and vertical locking Thumb Screws (1) & (2) and rotate Lamp Mounting Plate (3) to 45
degrees vertical. Rotate vertical locking thumbscrew clockwise and lock Lamp Mounting Plate into place in
this position.
2. Attach Socket (4) to MR16 lamp (5). Slide lamp between the Lamp Holder (6) and Lamp Spring (7) as shown.
3. Remove screw (12) and pull Safety Cable (11) through opening in Plaster Frame and attach to Trim using
screw (12).
4. Squeeze the two Torsion Springs (8) together and insert ends into slots on both Brackets (9) as shown.
5. Push trim towards ceiling until the Torsion Springs force the trim against the ceiling line.
B. Adjustment:
1. Rotate Scoop (10) vertically to desired position.
2. Make horizontal adjustment by holding outer flange on Trim and rotating horizontally.
NOTE: If necessary, pull the flange away from the ceiling slightly before rotating.
6
8
3
2
12
1 4
5
9
10
7
5
11
LOCATE TRIM FEATURE AWAY
FROM SIDE WITH SAFETY CABLE
4
9
8
9
SQUEEZE TORSION
SPRINGS AS SHOWN