Prescolite A4MRICAT - Manual

Instruction
Sheet
www.prescolite.com
•
Prescolite
TollFree
Technical
Support
1.888.PRS.4TEC
•
Hours:
8am
- 5pm
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 93003080
CAUTION: DO NOT ATTEMPT TO MODIFY OR REWIRE FACTORY-INSTALLED WIRING ON THE FIXTURE. SAFETY AND
PROPER OPERATION OF THE FIXTURE DEPEND ON THE INTEGRITY OF THE WIRING.
1. Install hanger bars into brackets. Install
the fixture in the ceiling using hanger
bars (sold separately), or mounting
channel or bar (by others) placed in
the adjustable mounting brackets.
Mount the fixture in the
ceiling so that the weight of the fix-
ture is supported by the hanger bars,
mounting channel, bar, and/or hanger
wires secured to the building structure.
2. Adjust the fixture so the bottom of the
plaster frame body is flush with the top
of the ceiling material and in alignment
with adjacent fixtures. Secure mounting
brackets by tightening wing nuts on
either side of the fixture.
3. Determine where the supply wiring
conduit will enter the J-Box and attach
it in conformance with the National
Electric Code.
4. Remove J-Box cover plate. Remove
appropriate knockout and assemble
appropriate connector for the supply
wire used. Connect ground wires to
green ground leads. Connect white
(common) to white (leads). Connect
power supply (line) to black lead(s).
Reinstall J-Box cover.
WARNING: DO NOT pinch wires
between J-Box/ballast cover
and J-Box. Consult a qualified
electrician for all other options
that require other wiring con-
figurations.
5. See trim instructions for lamp
installation.
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information and instructions
concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials, and proper lamping.
Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and during servicing or
relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed by qualified
service personnel. Product must be grounded to avoid potential electric shock or other potential hazard.
Product must be mounted in locations and at heights and in a manner consistent with its intended use,
and in compliance with the National Electrical Code and local building codes. The use of accessory equipment
not recommended by the manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light
emanating from product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains,
screens or the like to come into contact with the product or to block light from the product, as this may cause an unsafe condition.
WARNING - This product contains chemicals known to the State of California to cause cancer, birth defects and/or other
reproductive harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product.
Plaster
Frame
Bar Hanger
Brackets adjust
up and down
NOTE: Bar Hangers
sold separately.
NOTE: For
A4MHPAR20MH
remove (2) brackets
and discard when
using GE lamps.
Ceiling
Joists
T Bar
Grid
INSTALLATION INSTRUCTIONS
4’’ ADJUSTABLE DOWNLIGHT
A4MR, A4MRCP, A4SMR, A4SMRCP, A4PAR,
A4PARCP, A4MRICAT
Ceiling Cutout =
5” Maximum
701 Millennium Boulevard • Greenville, SC 29607
With representatives offices in principal cities throughout North America.
Copyright 2013, 7/9/13 revision, All Rights Reserved - Printed in U.S.A.
For proper trim Installation
plaster frame flange
cannot be below
bottom of ceiling.