Prescolite A6PAR30CP - Manual

Instruction
Sheet
Part No........................................................93008436
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information and
instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials, and
proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and during
servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed
by qualified service personnel. Product must be grounded to avoid potential electric shock or other
potential hazard. Product must be mounted in locations and at heights and in a manner consistent with
its intended use, and in compliance with the National Electrical Code and local building codes. The use
of accessory equipment not recommended by the manufacturer or installed contrary to instructions may cause an unsafe
condition. Do not block light emanating from product in whole or part, as this may cause an unsafe condition. Do not allow
items such as drapes, curtains, screens or the like to come into contact with the product or to block light from the product, as
this may cause an unsafe condition.
WARNING - This product contains chemicals known to the State of California to cause cancer, birth defects and/or other
reproductive harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product.
INSTALLATION INSTRUCTIONS
6" ADJUSTABLE DOWNLIGHT
A6PAR30, A6PAR30CP
www
.prescolite.com
Prescolite T
ollFree T
echnical Suppor
t
1.888.PRS.4TEC
Hours: 8am - 5pm ET
1. Install hanger bars into brackets. Install
the fixture in the ceiling using hanger bars
(sold separately), or mounting channel or
bar (by others) placed in the adjustable
mounting brackets. Mount the fixture in the
ceiling so that the weight of the fixture is
supported by the hanger bars, mounting
channel, bar, and/or hanger wires
secured to the building structure.
2. Adjust the fixture so the bottom of the
plaster flange is flush with the finished
ceiling line and in alignment with
adjacent fixtures. Secure mounting
brackets by tightening wing nuts on either
side of the fixture.
3. Determine where the supply wiring
conduit will enter the J-Box and attach it
in conformance with the National Electric
Code.
4. Remove J-Box cover plate. Remove
appropriate knockout and assemble
appropriate connector for the supply wire
used. Connect ground wires to green
ground leads. Connect white (common)
to white (leads). Connect power supply
(line) to black lead(s). Reinstall J-Box
cover. WARNING: DO NOT pinch
wires between J-Box/ballast
cover and J-Box. Consult a
qualified electrician for all other
options that require other wiring
configurations.
5. See trim instructions for lamp installation.
CAUTION: DO NOT ATTEMPT TO MODIFY OR REWIRE FACTORY-INSTALLED WIRING ON THE FIXTURE. SAFETY
AND PROPER OPERATION OF THE FIXTURE DEPEND ON THE INTEGRITY OF THE WIRING.
701 Millenium Boulevard • Greenville, SC 29607
With representatives offices in principal cities throughout North America.
Copyright 2013, 07/9/13 All Rights Reserved - Printed in U.S.A.
Bar Hangar Brackets
adjust up and down.
NOTE: Bar Hangars
sold seperately.
T Bar
Grid
Ceiling
Joists
Plaster
Frame
Make sure plaster
frame opening is flush
with bottom of ceiling
for proper trim installation
Ceiling Cutout =
6 3 /
4
" Maximum