Prescolite 9FLXPR - Manual

Instruction
Sheet
www
.prescolite.com
• Prescolite
TollFree
Technical Support
1.888.PRS.4TEC
• Hours: 8am - 5pm ET
101 Corporate Drive • Spartanburg, SC 29303
With representatives offices in principal cities throughout North America.
Copyright 2005, 08/05 revision, All Rights Reserved - Printed in U.S.A.
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .03626000
Instruction
Sheet
INSTALLATION INSTRUCTIONS
TRIM INSTALLATION
CAT. NO. 6FLXPR & 9 FLXPR
TRIM INSTALLATION
1. Assemble both torsion spring brackets supplied in packet by pressing the stud into the bracket
as shown in Fig. B.
2. Install torsion spring brackets in the sides of the housing by placing the tab in the upper hole
and pressing the stud in the 1/4" Dia. lower hole, Fig. B.
3. Lamp the fixture.
4. Place the torsion springs into the slots in the brackets as shown in Fig. A. Push the trim up into
the housing and allow the springs to draw the trim up against the ceiling.
Torsion Spring Bracket
Installed (2)
Engage Torsion Springs
in Brackets as Shown.
LFFTWSQ-6H or LFFQSQ-H9
Housing
Stud Fastener (2)
(Press into Bracket)
Torsion Spring
Bracket (2)
Torsion Spring (2)
Fig. A
Fig. B
Upperhole
Housing
1/4" Dia Hole
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information
and instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials,
and proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and
during servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed by
qualified service personnel. Product must be grounded to avoid potential electric shock or other potential hazard.
Product must be mounted in locations and at heights and in a manner consistent with its intended use, and in
compliance with the National Electrical Code and local codes. The use of accessory equipment not recommended by
the manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from
product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens or
the like to come into contact with the product or to block light from the product, as this may cause an unsafe condition.