Prescolite Recessed HID - Manual

Instruction
Sheet
www
.prescolite.com
• Prescolite
TollFree
Technical Support
1.888.PRS.4TEC
• Hours: 8am - 5pm ET
101 Corporate Drive • Spartanburg, SC 29303
With representatives offices in principal cities throughout North America.
Copyright 2005, 08/05 revision, All Rights Reserved - Printed in U.S.A.
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .05064500
Instruction
Sheet
INSTALLATION INSTRUCTIONS
RECESSED H.I.D.
CAUTION: To avoid electrical shock, be sure power supply is turned off before installing or servicing this fixture. Check
ballast for correct wattage, voltage and lamp type.
1. Install the fixture in the ceiling (see back) using bar hangers placed in the hanger brackets as shown. This fixture should be
mounted in such a manner so that the weight of the fixture is supported by the bar hangers and/or hanger wires secured to the
building structure.
2. Adjust the fixture so the bottom of the plaster flange is flush with the finished ceiling line. Accomplish this with the adjustment
screws securing the hanger brackets on either end of the fixture.
3. Remove J-Box cover plate. Remove appropriate knockout and assemble appropriate connector for the supply wire used. Connect
ground wires to green ground leads. Connect white (common) to white (leads). Connect power supply (line) to black lead(s).
Reinstall J-Box cover.
WARNING: DO NOT pinch wires between J-Box/ballast cover and J-Box. Consult a Qualified Electrician for all other
options that require other wiring configurations.
4. Install the ballast -
FE Ballast Installation: The ballast and housing are shipped separately, and the housing is factory wired for 277 VAC. If the
supply voltage is 277 VAC, no adjustment is required. For supply voltage of 120 VAC, disconnect the prewired 277 VAC
connector from the thermal protector and reconnect it to the 120V connector. Voltage connectors are identified as follows:
120 VAC - black wire 277 VAC - blue wire
Mate-N-Lock
Connectors
J-Box Cover
(removed for clarity)
Housing
B6 Bar Hanger
(supplied by Prescolite)
J-Box
J-Box
Cover
Reflector
Socket
Assembly
Hanger
Bracket
Mounting Bracket
Ballast Retaining
Strap
FE Ballast
J-Box
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information
and instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials,
and proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and
during servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed by
qualified service personnel. Product must be grounded to avoid potential electric shock or other potential hazard.
Product must be mounted in locations and at heights and in a manner consistent with its intended use, and in
compliance with the National Electrical Code and local codes. The use of accessory equipment not recommended by
the manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from
product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens or
the like to come into contact with the product or to block light from the product, as this may cause an unsafe condition.