Prescolite TAMPER-PROOF TRIM ASSEMBLIES - Manual

Instruction
Sheet
www
.prescolite.com
• Prescolite
TollFree
Technical Support
1.888.PRS.4TEC
• Hours: 8am - 5pm ET
101 Corporate Drive • Spartanburg, SC 29303
With representatives offices in principal cities throughout North America.
Copyright 2005, 08/05 revision, All Rights Reserved - Printed in U.S.A.
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .02831600
Instruction
Sheet
INSTALLATION INSTRUCTIONS
TAMPER-PROOF TRIM ASSEMBLIES
TRIM INSTALLATION
1. Obtain from packet two trim mounting brackets and two stud fasteners. Assemble
fasteners to brackets by pressing stud through bracket as shown in Fig. B.
2. Install trim mounting brackets by hooking tab into upper hole in housing and
pressing stud into 1/4 diameter lower hole, Fig. B.
3. Insert tamper-proof screw thru trim and retainer. Tamper-proof screw is retained
to trim as shown in Fig. C.
4. Push trim assembly up into housing and tighten tamper-proof screws.
UPPER HOLE
TAMPER-PROOF SCREW
1/4" DIA HOLE
TRIM ASSEMBLY
RETAINER
MOUNTING BRACKET
HOUSING
RETAINER
TRIM
TAMPER-PROOF SCREW
Fig. A Fig. B
STUD
FASTENER
MOUNTING BRACKET
HOUSING
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information
and instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials,
and proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and
during servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed by
qualified service personnel. Product must be grounded to avoid potential electric shock or other potential hazard.
Product must be mounted in locations and at heights and in a manner consistent with its intended use, and in
compliance with the National Electrical Code and local codes. The use of accessory equipment not recommended by
the manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from
product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens or
the like to come into contact with the product or to block light from the product, as this may cause an unsafe condition.