Prescolite TSC8G - Manual

Ins
tru
ctio
nS
he
et
w
w
w
.p
re
s
c
o
lit
e
.c
o
m
•P
res
co
lite
To
llF
ree
Te
ch
nic
al
Su
pp
ort
1.8
88
.P
RS
.4T
EC
•
Ho
urs
:8
am
-5
pm
ET
701 MillenniumBlvd., • Greenville, SC 29607
With representatives offices in principal cities throughout North America.
Copyright 2005, 08/05 revision, All Rights Reserved - Printed in U.S.A.
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .23795-PRE
Ins
tru
ctio
nS
he
et
INSTALLATION INSTRUCTIONS
TSC8BF, TSC8WBF, TSC8C, TSC8G
********************************************************************************************************************************************************
WARNING: - If any special control devices are used with this fixture, follow the instructions carefully to ensure full compli-
ance with N.E.C. requirements. If there are any questions, contact a qualified electrical contractor.
********************************************************************************************************************************************************
1.- Make sure socket (1) is adjusted to the desired position by loosening thumbscrew (2) and rotating socket bracket (3).
Re-tighten thumbscrew(2).
2..- Set trim (4) down over reflector or baffle assembly (5) (See Detail “A-A”).
3.-
Stretch coil spring (6) down and hook into hole(7) located at top of reflector or baffle assembly (5).
4.- Raise entire trim assembly up against recessed housing (8) (PURCHASED SEPARATELY) and ceiling.
5..- Install lamp (NOT FURNISHED).
CAUTION: All glass is fragile, use care when handling lamp.
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information
and instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials,
and proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and
during servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed by
qualified service personnel. Product must be grounded to avoid potential electric shock or other potential hazard.
Product must be mounted in locations and at heights and in a manner consistent with its intended use, and in
compliance with the National Electrical Code and local codes. The use of accessory equipment not recommended by
the manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from
product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens or
the like to come into contact with the product or to block light from the product, as this may cause an unsafe condition.