Prescolite 9424-13 - Manual

Ins
tru
ctio
nS
he
et
w
w
w
.p
r
e
s
c
o
li
te
.c
o
m
•P
res
co
lite
To
llF
ree
Te
ch
nic
al
Su
pp
ort
1.8
88
.P
RS
.4T
EC
•
Ho
urs
:8
am
-5
pm
ET
101 Corporate Drive, Suite L • Spartanburg, SC 29303
With representatives offices in principal cities throughout North America.
Copyright 2004, 08/04 revision, All Rights Reserved - Printed in U.S.A.
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .03609600
Ins
tru
ctio
nS
he
et
INSTALLATION INSTRUCTIONS
9424-13
1. Separate dark gray housing from diffuser using coin in proper slot.
2. Remove wrapper from ballast housing assembly.
3. Install mounting strap to outlet box as shown using outlet box screws.
4. Place the ballast housing assmebly into the housing. (For wall mounted fixtures position the ballast
assembly so the lampholder is located at the bottom.) Make electrical connections. Connect ground wires to
green ground leads. Connect white (common) to white leads. Connect power supply (line) to black leads.
WARNING: DO NOT PINCH WIRES. CONSULT A QUALIFIED ELECTRICIAN FOR ALL OTHER OPTIONS
THAT REQUIRE OTHER WIRING CONFIGURATIONS.
5. Mount fixture canopy with running thread nipple, lockwasher andhex nut provided. (For wall mounted
fixtures locate the coin slot at the bottom).
6. Install diffuser by snapping onto housing.
Hex Nut
3 1 /
2
" or 4"
Outlet Box
Mounting Strap
Housing
Ballast Housing
Assembly
Running Thread
Nipple
Lockwasher
SAFETY PROCEDURES FOR GROUNDING
Lockwashers are provided to insure correct grounding between
the mounting strap and the fixture. These must be placed on
the running thread nipples between the canopy and the nuts or
between the mounting screws and the canopy.
NOTE
In compliance with Underwriters Laboratories Standard UL
1570, 1571, or 1572; the use of a silicone base caulking
compound must be used to provide a watertight seal between
fixture and mounting surface to prevent electrical wiring from
getting wet.
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information
and instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials,
and proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and
during servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed by
qualified service personnel. Product must be grounded to avoid potential electric shock or other potential hazard.
Product must be mounted in locations and at heights and in a manner consistent with its intended use, and in
compliance with the National Electrical Code and local codes. The use of accessory equipment not recommended by
the manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from
product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens or
the like to come into contact with the product or to block light from the product, as this may cause an unsafe condition.