Prescolite PENDANT SERIES FIXTURE - Manual

Instruction
Sheet
www
.prescolite.com
•
Prescolite
T
ollFree
T
echnical
Support
1.888.PRS.4TEC
•
Hours:
8am
-
5pm
ET
101 Corporate Drive, Suite L • Spartanburg, SC 29303
With representatives offices in principal cities throughout North America.
Copyright 2004, 08/04 revision, All Rights Reserved - Printed in U.S.A.
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .01858100
Instruction
Sheet
INSTALLATION INSTRUCTIONS
PENDANT SERIES FIXTURE
FIG. 1
1. Make electrical connections. Connect ground
wires to green ground leads. Connect white
(common) to white leads. Connect power supply
(line) to black leads. (see wiring diagram).
WARNING: DO NOT pinch wires. Consult a
Qualified Electrician for all other options that
require other wiring configurations.
2. Fasten mounting plate to outlet box.
3. Twist canopy cover in place. (Fig. 1)
3 1 /
4
" or 4" O.B.
Cam Action
Retention
Mounting Plate
with keyhole
slots (screws do
not have to be
removed from O.B.)
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information
and instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials,
and proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and
during servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed by
qualified service personnel. Product must be grounded to avoid potential electric shock or other potential hazard.
Product must be mounted in locations and at heights and in a manner consistent with its intended use, and in
compliance with the National Electrical Code and local codes. The use of accessory equipment not recommended by
the manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from
product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens or
the like to come into contact with the product or to block light from the product, as this may cause an unsafe condition.