Prescolite 1102-1108 - Manual

Instruction
Sheet
www
.prescolite.com
• Prescolite
TollFree
Technical Support
1.888.PRS.4TEC
• Hours: 8am - 5pm ET
101 Corporate Drive • Spartanburg, SC 29303
With representatives offices in principal cities throughout North America.
Copyright 2005, 07/05 revision, All Rights Reserved - Printed in U.S.A.
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .02588500
Instruction
Sheet
INSTALLATION INSTRUCTIONS
1102-1108
NOTE: UNDERWRITERS LABORATORIES REQUIRES THAT
MOUNTING STRAP MUST BE UTILIZED WHEN MOUNTING
FIXTURE.
1. Attach mounting strap to outlet box using outlet box
screws. Install mounting screws in mounting strap
(approximately 1/4") to match keyway holes in the
fixture. Terminate ground wire (by others) by using cup
washer and the green ground screw provided in
mounting strap.
2. Make electrical connections. Connect ground wires to
green ground leads. Connect white (common) to white
leads. Connect power supply (line) to black leads. (see
wiring diagram). Push splices into outlet box. (Fig. 3 or 4)
WARNING: DO NOT pinch wires. Consult a Qualified
Electrician for all other options that require other
wiring configurations.
3. Place the fixture over the outlet box making sure that
mounting screws extend through the keyway holes in
the fixture. Turn the fixture clockwise and tighten the
screws.
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information
and instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials,
and proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and
during servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed by
qualified service personnel. Product must be grounded to avoid potential electric shock or other potential hazard.
Product must be mounted in locations and at heights and in a manner consistent with its intended use, and in
compliance with the National Electrical Code and local codes. The use of accessory equipment not recommended by
the manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from
product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens or
the like to come into contact with the product or to block light from the product, as this may cause an unsafe condition.