Prescolite ALCF-1, 4, 5, 6 - Manual

Instruction
Sheet
www
.prescolite.com
• Prescolite
TollFree
Technical Support
1.888.PRS.4TEC
• Hours: 8am - 5pm ET
101 Corporate Drive • Spartanburg, SC 29303
With representatives offices in principal cities throughout North America.
Copyright 2005, 08/05 revision, All Rights Reserved - Printed in U.S.A.
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .03424500
Instruction
Sheet
INSTALLATION INSTRUCTIONS
ALCF-1, 4, 5, and 6
1. Install the housing by nailing the mounting brackets on
the housing to the frame support as shown in Fig. 1, or
frame in the housing as desired for wet or dry wall
construction.
2. Adjust the mounting brackets to locate the housing as
required for profile trim (Fig. 2).
3. Install the conduit (by others) to align with one of three
7/8" diameter knockouts located on the sides and
bottom of housing. Remove the wingnut retaining the
socket mounting plate and lift out plate.
4. When installed in concrete pour or mortar and in a
situation where direct water exposure is frequent, the
concrete or mortar is to be suitably treated with a
sealing or repelling agent to insure that the fixture
housing does not remain continuously wet.
Support Frame
(By Others)
Housing Installation
Figure 1
Conduit
(By Others)
Housing
Fastener (Nail)
(By Others)
Profile Trim
Figure 2
Adjustable Mounting
Bracket (2)
Adjustable
Mounting
Bracket (2)
Conduit
Entry
Profile Trim
(Wet or Drywall
Construction)
Housing
Conduit
(By Others)
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information
and instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials,
and proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and
during servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed by
qualified service personnel. Product must be grounded to avoid potential electric shock or other potential hazard.
Product must be mounted in locations and at heights and in a manner consistent with its intended use, and in
compliance with the National Electrical Code and local codes. The use of accessory equipment not recommended by
the manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from
product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens or
the like to come into contact with the product or to block light from the product, as this may cause an unsafe condition.