Prescolite AKTCLS - Manual

Instruction
Sheet
www
.pr
escolite.com
Pr
escolite T
oll Fr
ee T
echnical Support
1.888.PRS.4TEC
Hours: 8am-5pm ET
701 Millennium Blvd, Greenville, SC 29607
With representatives offices in principal cities throughout North America.
Copyright 2007, 11/21/07, All Rights Reserved - Printed in U.S.A.
Part Number 02371500
1
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW SAFETY INSTRUCTIONS. Follow label information and
instructions concerning locations, installation near combustible materials, insulation, building materials, and proper lamping.
Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and during servicing or relamping,
turn off power at fuse or circuit breaker.
All servicing must be performed by qualified service personnel. Product must
be grounded to avoid potential electric shock or other potential hazard. Product must be mounted in locations
and at heights in a manner consistent with its intended use, and in compliance with the National Electrical Code
and local codes.
BACK PLATE INSTALLATION
1. Attach track feed connector (AKTEF or AKTSL, ordered separately) to back plate using conduit adaptor and lock
nut as shown on installation diagram.
2. Pull supply wires from junction box through conduit adaptor. Secure back plate to junction box using screws supplied
with junction box or by others.
3. Snap switch into opening in bracket. Use canopy to determine proper location.
INSTALLATION INSTRUCTIONS
FOR AKTCLS TRACK CURRENT LIMITER DEVICE
FOR USE WITH PRESCOLITE ® AKT ONE/TWO CIRCUIT TRACK SYSTEM ONLY.
READ INSTALLATION INSTRUCTIONS BEFORE INSTALLING THE TRACK SYSTEM.
SAVE INSTRUCTIONS FOR REFERENCE WHEN MAKING ADDITIONS OR CHANGES
IN THE TRACK SYSTEM CONFIGURATION.
INSTALLATION INSTRUCTIONS
AKTCLS
TRACK CURRENT LIMITER DEVICE
BACK PLATE
LOCKNUT
CONDUIT ADAPTER
AKTCLS
Current Limiter Switch
AKTEF or AKTSL
(ordered separately)