Prescolite ARCHITRAK SYSTEM AKTMP - Mono-point Adaptor - Manual

Instruction
Sheet
www
.prescolite.com
• Prescolite
TollFree
Technical Support
1.888.PRS.4TEC
• Hours: 8am - 5pm ET
101 Corporate Drive • Spartanburg, SC 29303
With representatives offices in principal cities throughout North America.
Copyright 2005, 08/05 revision, All Rights Reserved - Printed in U.S.A.
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .157850100
Instruction
Sheet
INSTALLATION INSTRUCTIONS
FOR AKTMP MONOPOINT ADAPTOR
FOR USE WITH PRESCOLITE ONE/TWO CIRCUIT ARCHITRACK SYSTEM ONLY.
READ INSTALLATION INSTRUCTIONS BEFORE INSTALLING THE TRACK SYSTEM
SAVE INSTRUCTIONS FOR REFERENCE WHEN MAKING ADDITIONS TO OR CHANGES IN THE TRACK SYSTEM.
INSTALLATION
1. Attach universal mounting ring to junction box with two screws provided with junction box.
2. Pull black, white, ground wires through opening of mounting ring.
3. Connect black (hot) house wire to black wire from monopoint adaptor. Secure with approved with connector. Connect white (neu-
tral) house wire to white wire from monopoint adaptor.
4. Push wire connections into junction box.
5. Attach monopoint adaptor to universal mounting ring with two flat head screws provided.
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information
and instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials,
and proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and
during servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed by
qualified service personnel. Product must be grounded to avoid potential electric shock or other potential hazard.
Product must be mounted in locations and at heights and in a manner consistent with its intended use, and in
compliance with the National Electrical Code and local codes. The use of accessory equipment not recommended by
the manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from
product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens or
the like to come into contact with the product or to block light from the product, as this may cause an unsafe condition.
INSTALLATION INSTRUCTIONS
ARCHITRAK
®
SYSTEM
JUNCTION BOX
UNIVERSAL MOUNTING RING
WONOPOINT ADAPTOR
WHITE (NEUTRAL)
WIRES
WIRENUTS NOT PROVIDED
GROUND WIRES
WHITE (NEUTRAL)
WIRES
JUNCTION BOX SCREWS
NOT PROVIDED BY H.L.I. BLACK (HOT) WIRES