Prescolite TA30B/C/G & BF - Manual

www
.prescolite.com
• Prescolite
TollFree
Technical Support
1.888.PRS.4TEC
• Hours: 8am - 5pm ET
101 Corporate Drive • Spartanburg, SC 29303
With representatives offices in principal cities throughout North America.
Copyright 2005, 08/05 revision, All Rights Reserved - Printed in U.S.A.
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .05489600
Instruction
Sheet
INSTALLATION INSTRUCTIONS
TA30B/C/G & BF
1. Install lampholder from housing into mounting hole in top of yoke.
2. Install lamp. Use up to 75W PAR-30, 75W R-30 lamps.
3. To install trim into housing, squeeze torsion spring legs together
and place them into torsion spring brackets as shown. Push trim
up into housing aperture until flange seats flush against ceiling.
Lampholder
Yoke
Lamp (by others)
Trim Flange
Torsion Spring
Hex Socket
Cap Screw
Allen Wrench
Torsion Spring
Bracket
INSTALLING THE TRIM
AIMING THE LAMP
Note: Trim removal is not required for relamping.
1. Trim may be manually rotated and yoke tilted from vertical to obtain desired aiming angle.
Caution: Before making lamp angle adjustment, turn off fixture and allow lamp to cool.
Note: For vertical aiming, unlock yoke by loosening hex socket cap screw with a
3 /
32
Allen wrench. (See item 2. below for tightening and loosening).
2. When desired aiming angle is accomplished, lock yoke in place by tightening hex socket cap screw located on inside of
cone or baffle: turn wrench clockwise to tighten, counterclockwise to loosen.
Note: Trim or lamp removal is not required for adjustment.
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information
and instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials,
and proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and
during servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed by
qualified service personnel. Product must be grounded to avoid potential electric shock or other potential hazard.
Product must be mounted in locations and at heights and in a manner consistent with its intended use, and in
compliance with the National Electrical Code and local codes. The use of accessory equipment not recommended by
the manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from
product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens or
the like to come into contact with the product or to block light from the product, as this may cause an unsafe condition.