Prescolite TAW66 - Manual

Ins
tru
ctio
nS
he
et
w
w
w
.p
re
s
c
o
lit
e
.c
o
m
•P
res
co
lite
To
llF
ree
Te
ch
nic
al
Su
pp
ort
1.8
88
.P
RS
.4T
EC
•
Ho
urs
:8
am
-5
pm
ET
701 Millennium Blvd., • Greenville, SC 29607
With representatives offices in principal cities throughout North America.
Copyright 2007, 11/06/07 revision, All Rights Reserved - Printed in U.S.A.
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .023713-PRE
Ins
tru
ctio
nS
he
et
INSTALLATION INSTRUCTIONS
TA60, TA65, TAW65,TA66, TAW66
*********************************************************************************************************************************************************
WARNING: If any special control devices are used with this fixture, follow the instructions carefully to assure full compliance with
N.E.C. requirements. If there are any questions, contact a qualified electrical contractor.
*********************************************************************************************************************************************************
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information
and instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials,
and proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and
during servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed by
qualified service personnel. Product must be grounded to avoid potential electric shock or other potential hazard.
Product must be mounted in locations and at heights and in a manner consistent with its intended use, and in
compliance with the National Electrical Code and local codes. The use of accessory equipment not recommended by
the manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from
product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens or
the like to come into contact with the product or to block light from the product, as this may cause an unsafe condition.
1- To adjust Fixture to correct Ceiling thickness, loosen the Wingnut (1) inside the Housing (2) and lower the Housing
(2) until the bottom edge is flush with the Ceiling (3). Then re-tighten the Wingnut (1).
2- Remove Eyeball (4) from Trim (7). Slide Socket (6) down along length of Mounting Spring (8) and remove. Slip
Socket (6) down through center of Trim (7).
3- Attach end of Mounting Spring (8) to rectangular slots of Socket hole in Mounting Bracket (5). Push Trim (7)
upward until flush with Ceiling (3).
4- Attach Socket (6) to Eyeball (4). Compress Socket Spring Legs (10) while inserting into Slots (9) of opening in top
of Eyeball (4). Then release.
5- Snap Eyeball (4) back into Trim (5).
6- Install Lamp (NOT FURNISHED).
CAUTION: ALL GLASS IS FRAGILE,
USE CARE WHEN HANDLING LAMP.