Purus Living 800 - Drop/Twist Grate - Manual (Page 14)

14
PURUSLINE LIVING WETROOM SOLUTION Concrete
Stage 10
After adjusting the height, turn the frame
upside-down and fill the frame-edge fully
with tile adhesive to fix the grate into
position.
Then turn the frame back over and install it
while the adhesive is still wet.
NOTE: When installing, the whole area
around the frame should be fully filled with
adhesive. Clean any excess tile adhesive that
might fall into the gully straight away.
The grate when installed must be horizontal
and flat. It also must be level with the ceramic
tile surface and not at an angle or on a slope.
Tile to the desired pattern, using flexible
EN12004 C2 classified tile adhesive applied
using a notched trowel in accordance with
the code of practice BS5385:2009.
Finally grout the gaps with flexible, water
proof, anti-mould grout, ensuring that no
grout falls into the gully body. Allow to dry
and settle for 48 hours.
If tile adhesive or grout falls into the gully
immediately clean it up.
Remove grate supports from underneath
the grate.
NOTE: Once installed and the grout is fully
dry, check for leaks before using.
Fix tiles to BS5385 Standard.
15
Tile
adhesive
Frame edge
Rebate
Flexible grout
Tiles
Tile adhesive
After the tiles are installed, joint the tile
frame with flexible grout.
02831