Bosch 4310 - Manual (Page 12)

-12-
Assembly
1. With the miter arm locked in the down position,
push the dust elbow onto the dust port. Push the
dust bag onto the elbow and rotate both to de-
sired position. (Figure 4).
2. Position dust chute/bag so that it does not inter-
fere with the tool during the cutting operation for
all miter/bevel settings. Make sure dust bag does
not interfere with the slide rails during slide cut-
ting.
3. The dust bag requires emptying when full of
sawdust. Empty it frequently and after completion
of sawing. Carefully remove dust bag from dust
elbow. Empty dust bag in proper trash
bin by unzipping the bag. Be extremely careful of
dust disposed, materials in fine particle form may
be explosive. Do not throw sawdust on an open-
fire. Spontaneous combustion, may in time, result
from mixture of oil or water with dust particles.
NOTE: The dust port accepts the Bosch VAC004
Vacuum Hose Adapter, which allows connection to
a Bosch 35mm vacuum hose.
When sawing chemically pressure
treated lumber, paint that may be
lead based, or any other materials that may contain
carcinogens, use special precautions. A suitable res-
pirator must be worn by all personnel entering the
work area. Work area should be sealed by plastic
sheeting and persons not protected should be kept
out until work area is thoroughly cleaned.
Assembling Dust Elbow And Dust Bag
figure 4. Dust Elbow and Dust Bag
Dust
Elbow
Dust Bag
Dust port
!
WARNING
Attaching Miter lock Knob
Locate the miter gauge lock knob from among the
loose parts, and thread shaft on lock knob into hole
provided.
Attaching Rear Cord Wrap
Locate the rear cord wrap from among the loose
parts, position rear cord wrap as shown and secure
with washer and phillips screw provided.
UNLOCK
LOCK
Miter Gauge
lock Knob
Rear Cord Wrap
phillips Screw
Washer
figure 4a. Attaching Miter lock Knob
figure 4b. Attaching Rear Cord Wrap
BM 2610012089 03-10 E:BM 2610012089 03-10 E 3/30/10 7:40 AM Page 12