RF-Link AVS-5811 5.8GHz Wireless Audio/Video Sender with IR Remote Control Extender - Manual (Page 5)

4B – Remote control window receives IR rays from remote controller.
5A – Directional 5.8GHz A/V antenna sends A/V signal from source equipment.
5B – Directional 5.8GHz A/V antenna receives audio and video signal.
6 – Power on/off switch.
7 – DC power input, connect to power supply. (12v).
8 – IR Mouse output, to remotely control source AV equipment.
9 – No available (To TV)
10A–Video Jack, (yellow), input from source AV equipment.
10B–Video Jack, (yellow), output to TV.
11A–Audio Jack, Right (red), input from source AV equipment.
11B–Audio Jack, Right (red), output to TV.
12A–Audio Jack, Left (white), input from source AV equipment.
12B–Audio Jack, Left (white), output to TV.
To enjoy a life of wireless video and audio, just connect the transmitter to
whatever A/V source you like and connect the receiver to a TV, monitor or
speaker in another location.
□ Transmitter
□ Receiver
NOTE: Make sure the ON/OFF switch is in the 「OFF」position before connection
4. Setup Guide
1. Connect one end of the RCA cable (or
scart cable) to the audio and video jacks,
and connect the other end to a source
device as well.
2. Connect the DC plug of the adapter to the
DC jack, and connect the power supply to
an outlet.
3. Keep the IR window oriented toward the
source AV equipment, or alternatively use
the IR Mouse to remotely control it.
1. Connect one end of the RCA cable (or
scart cable) to the audio and video jacks
and connect the other end to a TV (or
monitor, speakers) on which you like to
enjoy a program.
2. Connect the DC plug of the adapter to
the DC jack, and connect the power
supply to an outlet.
3. Keep the IR window oriented toward
your remote controller.
5 4