Blue Rhino TW120 FC-0024 - Manual (Page 104)

ASSEMBLY
TW120 01/11 Assembly Section 3-8
© 2011 Alamo Group Inc.
ASSEMBL
Y
DRIVELINE ATTACHMENT
Before starting assembly, make certain that all paint, dirt, and grease are removed from gearbox shaft (1). To
ease assembly apply a light coat of grease to splines and assemble. Do not assemble a driveline without a
shield.
1. Attach the slip clutch end of the driveline to the gearbox input shaft securely. Make certain that the slip
clutch is fully onto the input shaft splines. Tighten the locknuts (2) alternately until they have reached the
proper torque. Refer to Torque Chart in Maintenance Section.
SHIELD ASSEMBLY
Remove and discard the two top bolts from the Center Gearbox. Attach Bracket (1) to the Center Gearbox with
M10 x 40 Bolts (2), and Flatwashers (3) in the same hole location. Install Shield (5) and retain with 1/2” Wing
Nut (4).