S&S Cycle Lloydz Motorworkz 107 and 114 Big Bore Kit for Victory Motorcycles User Manual
S&S Cycle For motorcycles
Installation Instructions for Lloydz Motorworkz 107"
and 114" Big Bore Kit for Victory® Motorcycles
Instruction
510-0007
10-5-10
All rights reserved.
Printed in the U.S.A.
25 Railroad Ave
PO Box 11
Pine Bush, NY 12566
KIT CONTENTS:
•
2 – 4.125” (104.77mm) pistons matched to cylinders
•
2 – piston pins
•
2 – Piston ring sets for front and rear pistons
•
4 – Piston pin clips
•
2 – Head gaskets
•
2 – Victory® cylinders sleeved and machined
ADDITIONAL PARTS REQUIRED:
•
2 – 5244365 Stock Victory base gaskets
•
2 – Stock Victory rocker cover gaskets for the specific model you are
working on
•
Any other o-rings, gaskets, assembly lube, and oil called out in your
Victory Service Manual for performing an engine build and installation
into the specific motorcycle you are working on.
SPECIAL TOOL REQUIREMENTS:
•
Victory service manual – Available through Polaris® dealers
•
Piston C-clip installer
•
Piston ring compressor
•
Piston ring expander
•
Piston ring end gap filing tool
•
Digital or dial calipers
•
Feeler gauge
•
Air fuel ration meter
•
The safety of the motorcycle rider is dependent on proper installation of this product. If you are not certain of your capabilities or do
not have the correct tools for this installation, please consult a dealer to have it done. Improper installation of this product could result
in injury or death to the rider.
•
Be sure to disconnect the battery of your motorcycle before starting on this procedure. Accidental starting of the motorcycle could
cause injury to you or others around you during the installation.
•
Air/Fuel mixture MUST be checked prior to riding. A proper A/F ratio must be obtained to ensure longevity and prevent premature
failure. Engine damage caused by incorrect fuel ratios will not be covered under warranty.
WARNING
Lloydz Motorworkz Big Bore Kit