S&S Cycle Incorrectly Machined Tappet Guides - Manual

A limited number of S&S tappet guides for V2 Big Twins were shipped with incorrect machining.
These items can be identified by examining the machined areas indicated in the photograph and
measuring the distance from the gasket surface to the angle cut. The incorrectly machined guides
distort when installed, which causes the lifter to bind.
To obtain correct replacement parts, contact an S&S Technical Services Representative at 608-
627-1497. The representative will issue a Return Authorization (RA) number and arrange a prompt
exchange of parts.
We regret this inconvenience.
Service Bulletin #36
2000
Revised 2-9-00
Copyright ©, 2000
by S&S Cycle, Inc.
All rights reserved.
Printed in the U.S.A.
S&S
®
Cycle, Inc.
Box 215
Viola, Wis. 54664
Phone 608-627-1497
•
Fax 608-627-1488
Service Bulletin #36
Incorrectly Machined Tappet Guides