S&S Cycle Throttle-by-Wire Throttle Hog Throttle Body - Manual (Page 2)

2
Thank you for choosing S&S® Cycle’s throttle-by-wire Throttle Hog throttle body. This fits all 2008-Up Harley-Davidson® motorcycles originally
equipped with an electronic throttle control throttle body. Please read the following steps to help guide you through the proper installation of
the kit.
• Before doing any of the following installation, be sure to disconnect the negative cable of your battery.
• Consult an appropriate factory service manual for safety instructions on how to disconnect the fuel system from your motorcycle.
• Gasoline is extremely flammable. Please be sure to work in a well ventilated area and do not have an open flame near the work area.
• The following installation should be only done by a qualified technician with the proper tools and training. If you are not certain of
your capabilities or do not have the correct tools for this installation, S&S recommends you consult a shop to have it done for you.
Improper installation of this product could result in damage to the motorcycle and motorcycle components.
Note: You will have to transfer the following components from the stock induction module to the S&S® throttle-by-wire Throttle Hog throttle body. If this
is a new installation or custom application, these parts will need to be sourced from a certified Harley-Davidson® dealer:
• Temperature/Manifold Absolute Pressure (MAP) Sensor H-D® PN 32319-07
• Fuel Rail Assembly (including M5x.8 Torx head mounting screw, fuel line, fuel rail, and fuel rail plate) H-D® PN 61208-10 and H-D® PN 27721-08.
• Depending on the chosen air cleaner kit, the Induction Module Bracket H-D® PN 27712-08 with 4705 screws may be retained as well. S&S
recommends using the Super Stock™ Stealth Air Cleaner kits in which this bracket would not be needed.
The following parts will also be required for the S&S throttle-by-wire Throttle Hog throttle body.
• Screamin’ Eagle® Pro high flow injectors H-D® PN 27796-08
• Intake Manifold Flange H-D® PN 27059-05A (2pk) (58mm & 66mm Only)
• Intake Manifold Flange Seal H-D® PN 27035-05 (2pk) (58mm & 66mm Only)
• Intake Manifold Flange and Seal Kit S&S PN 16-0250 (70mm Only)
• A performance motorcycle tuning module. S&S recommends Dynojet® PowerVision, or Screamin’ Eagle Super Tuner
Tool Requirements:
¼" Allen Wrench
3/16" Allen Wrench
5/32" Allen Wrench
¼" Ratchet
T25 Torx socket
Torque Wrench
Blue Threadlocker
WARNING
CAUTION
Picture 1