Salsbury Industries 71000 Series Vented Lockers Single Tier - Manual

Vented Lockers – 71000 Series
Single Tier Installation Instructions
Phone: 1-800-562-5377 Int’l Phone: 323-846-6700
Fax: 1-800-562-5399 Int’l Fax: 323-846-6800
www.lockers.com [email protected]
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2014 Salsbury Industries. All rights reserved. Page 1 of 5 3/27/14
SALSBURY INDUSTRIES
1010 East 62 nd Street, Los Angeles, CA 90001-1598
Thank you for selecting Salsbury’s vented single tier lockers. These instructions are intended to assist you in assembling the lockers. Assembly of the various locker components will be
with #10 - 24 x 3/8” long slot less screws and #10 nuts (provided). Loosely fasten a screw and a nut into every set of mating holes with the screw heads positioned on the outside of the
locker or on the exposed surface.
One Wide Locker Assembly
Step 1: Attach the top shelf, bottom shelf, and the first single coat hook to the back
panel.
Step 2: Turn the back panel on its back with the shelves pointing upward. Attach the
first side panel, the left rear leg, and the hat shelf to the assembly from Step 1. On 12”
and 15” deep lockers attach the double coat hook to the bottom of the hat shelf and
attach a second single coat hook to the first side panel. On 18” deep lockers omit the
double coat hook and substitute a single coat hook with a double bend (not shown)
instead of the second single coat hook (this will accommodate the coat rod).
Step 3: Attach the second side panel and the right rear leg to the assembly of Step 2.
On 12” and 15” deep lockers attach a third single coat hook. On 18” deep lockers
substitute a single coat hook with a double bend for the third single coat hook and
install the coat rod as shown on page 3. The locker chassis is now complete.
Step 4: Attach the pre-assembled door frame onto the assembly of Step 3.
Step 5: Tighten all fasteners checking for squareness of the locker while tightening.
Attach optional sloping hood, end bases or front base (see pages 4 and 5).
Step 6: Place the locker in the installed location and anchor to the floor, wall, or to
both. Individual job conditions will dictate the type of fastening anchors to use (not
provided).
Step 7: Fasten all lockers in a row together by installing fasteners provided through
the side panels. Installation is now complete.