Salsbury Industries S-61000 Series See Through Lockers Single Tier - Manual (Page 2)

See Through Lockers – S-61000 Series
Single Tier Installation Instructions
Phone: 1-800-562-5377 Int’l Phone: 323-846-6700
Fax: 1-800-562-5399 Int’l Fax: 323-846-6800
www.lockers.com [email protected]
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2014 Salsbury Industries. All rights reserved. Page 2 of 5 3/27/14
SALSBURY INDUSTRIES
1010 East 62 nd Street, Los Angeles, CA 90001-1598
Three Wide Locker Assembly
Step 1: Attach a top shelf, a bottom shelf, and the first single coat hook to a back
panel.
Step 2: Turn the back panel on its back with the shelves pointing upward. Attach the
first side panel, the left rear leg, and the first hat shelf to the assembly of Step 1. On
12” and 15” deep lockers attach the first double coat hook to the bottom of the first hat
shelf and attach a second single coat hook to the first side panel. On 18” deep lockers
omit the double coat hook and substitute a single coat hook with a double bend (not
shown) instead of the second single coat hook (this will accommodate the coat rod).
Step 3: Attach the second top shelf, the second bottom shelf, and an additional single
coat hook to the second back panel as in step 1.
Step 4: Simultaneously attach the assembly of Step 3 (second Step 1 assembly), the
second side panel, and the second hat shelf to the assembly of Step 2. On 12” and
15” deep lockers attach the second double coat hook and attach two additional single
coat hooks to the second side panel. On 18” deep lockers omit the second double
coat hook and substitute two additional single coat hooks with a double bend (not
shown) instead of the single coat hooks and install a coat rod as shown on page 3.
Step 5: Attach the third top shelf, the third bottom shelf, and an additional single coat
hook to the third back panel as in steps 1 and 3.
Step 6: Simultaneously attach the assembly of Step 5 (third Step 1 assembly), the
third side panel, and the third hat shelf to the assembly of Step 4. Repeat the Step 4
coat hooks instructions to attach additional coat hooks and coat rods.