Salsbury Industries 9600 Series Wire Shelving Stationary and Mobile - Manual

Wire Shelving – 9500 / 9600 Series
Stationary and Mobile
Assembly Instructions
Thank you for selecting 9500-S / 9600-S (Stationary) or 9500-M / 9600-M (Mobile) wire shelving from Salsbury Industries. We are confident that the
quality and construction of the wire shelving will prove to be a good investment. These instructions are to assist you in assembling the wire shelving.
Preliminary Notes
SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Phone: 1-800-562-5377 Int’l Phone: 323-846-6700
Fax: 1-800-562-5399 Int’l Fax: 323-846-6800
www.lockers.com engineering @ lockers.com
Salsbury Industries assumes no product assembly or installation liability. Copyright © 2010 Salsbury Industries. All rights reserved. (Rev. 01, 12/16/2009)
Please read the complete assembly instructions before attempting to
assemble the wire shelving. Check the parts to be sure that they are
correct for the job and that there is no damage. First review all
illustrations to identify part names.
Each wire shelving unit includes
1. Four (4) posts with adjustable feet
2. Four (4) adjustable shelves with sixteen (16) shelf clips
3. Four (4) locking casters (if Mobile wire shelving ordered)
Assembly
Note: The top end of a post is identified by the first groove
being about 1/2” from the end. The bottom end of the post is
identified by the first groove being about 2-1/2” from the end.
Ensure that all four (4) posts are positioned in the same
direction when installing the shelf clips for the bottom shelf.
1. Install both halves of one shelf clip at the lowest desired shelf
position on the bottom end of one of the posts. The tabs and
notches on each half should mate securely, holding the clip in
position. Note that there are ridges inside the clips that lock into
grooves on the post. There are alignment marks on the outside
of the clips to facilitate positioning the clips such that the
interior ridges mate with the post grooves. Install the clips in the
exact same position on the other three (3) posts.
2. Indentify the bottom versus the top of a shelf by noting that
the top of the shelf has the large wire grid and that the markings
on the collars on the corners of the shelf read upright. Slide a
post up through the bottom end of the collar on one of the corners of
a shelf until the shelf clip is inside the collar except for about 1/8” of
the shelf clip still visible. Repeat for the other three (3) posts,
installing each in another corner of the shelf. Stand the unit upright
with the bottom ends of the posts on the floor.
3. Install the remaining three (3) shelves up from the bottom at the
desired positions, repeating Steps 1 and 2.
4. Turn the unit on its side and install the adjustable feet (Stationary)
or casters (Mobile), as desired. If casters are being installed, the
adjustable feet that are in the box with the posts will not be used.
The assembly is now complete.
TAB & NOTCH
ADJUSTABLE
FOOT
SHELF
CLIP
SHELF
ADJUSTABLE
FOOT
POST
CASTER
SHELF
CLIP
SHELF
ALIGNMENT MARK SHELF
CLIP
POST
“UP”
SHELF
POST
POST
ADJUSTABLE
FOOT
CASTER