Salsbury Industries 1512 Series Large Commercial Signage - Manual (Page 2)

Large Commercial Signage - 1511/1512 Series
Assembly & Installation Instructions
6. Slide the signage panel into the two (2) opposing U-channels and
all the way down into the U-channel on the lower cross arm. See
illustration 3.
Illustration 3
7. Place the upper cross arm into position with the U-channel
enclosing the top edge of the signage panel. Fasten the cross arm
using the remaining two (2) right-angle brackets and four (4) 5/16” x
5” long hex head bolts. The bolts are installed from the outside of
each post through the short leg of the outside bracket, through the 4”
square post, and then into the nuts installed in the short leg of the
bracket previously installed inside the ends of the upper cross arm.
See illustration 4.
Illustration 4
8. Tighten the eight (8) 5/16” x 5” long bolts, ensuring that the post
assembly is properly aligned, flat, and square. Attach each of the
four (4) stub arms onto the long legs of the right-angle brackets with
two (2) 1/4”-20 x 1/2” long flat head screws. See illustration 5.
Illustration 5
SALSBURY INDUSTRIES
1010 East 62 nd Street, Los Angeles, CA 90001-1598
Phone: 1-800-624-5269 Int’l Phone: 323-846-6700
Fax: 1-800-624-5299 Int’l Fax: 323-846-6800
www.lockers.com engineering @ mailboxes.com
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2007 Salsbury Industries. All rights reserved. (Rev. 03, 7/12/2007)