Salsbury Industries 4375 Mail Package Drops Pedestal - Manual

SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Phone: 1-800-624-5269 Int’l Phone: 323-846-6700
Fax: 1-800-624-5299 Int’l Fax: 323-846-6800
www.mailboxes.com engineering @ mailboxes.com
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2011 Salsbury Industries. All rights reserved. (Rev. 03, 12/15/11)
Mail Package Drops – 4375
Pedestal Installation Instructions
U.S.P.S. APPROVED
Installing Mail Package Drop on a Pedestal
Thank you for selecting Salsbury’s 4375 mail package drop.
This instruction sheet is for installing the 4375 mail package drop on
a pedestal. Other installation instructions are available for mounting
the pedestal in a concrete footing.
When you install a curbside or roadside mailbox, make sure that it is
easily accessible to the mail carrier. By regulation a locked mailbox
should be 41” to 45” from the ground or street surface up to the point
of mail entry. The door should be set back 6” to 8” back from the
front face of the curb or the road edge. However, you should check
with your local postmaster to ensure that the mailbox is installed
according to local regulations. It is important to note that it is not the
responsibility of mail carriers to open mailboxes that are locked,
accept keys for this purpose, or lock mailboxes after delivery of the
mail.
All hardware to install the mail package drop is provided with the mail
package drop. To install the mail package drop, unlock and open the
front door or rear door of the mail package drop and install four (4)
7/16” - 14 x 1.00” long hex head bolts through the four (4) outer
holes in the inside floor of the mail package drop and through the top
plate of the pedestal. Install 7/16” flat washers and 7/16” hex nuts on
the ends of the four (4) bolts protruding below the bottom of pedestal
top plate. Installation is now complete.
Additional hardware provided is not needed and may be discarded.