Salsbury Industries 3786 Combination Lock - Manual

SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Phone: 1-800-624- 5269 Int’l Phone: 323-846-6700
Fax: 1-800-624- 5299 Int’l Fax: 323-846-6800
www.mailboxes.com engineering @ mailboxes.com
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2014 Salsbury Industries. All rights reserved. (Rev. 04, 1/22/2014)
Combination Locks - 2086, 2286, 2486, 3486, 3686, 3786
Operation & Change Instructions
Combination Factory Setting
Make sure the dial knob “0” is aligned with the proper hub number 1,
2, 3, or 4 on the lock body hub. The factory hub number is marked
on the upper left corner of the label on the rear of the lock. The
factory hub number position results in the combination number
setting that is marked on the rear label. See illustration.
To Operate The Lock
There is an index to which the dial number is aligned on both the lock
body and the front of the door to which the lock is fastened.
1. Turn dial to left (CCW - counterclockwise) at least four times
and stop when first number is aligned with index.
2. Turn dial to right (CW - clockwise) passing first number and stop
when second number is aligned with index.
3. Turn dial to left (CCW) and stop when third number is aligned
with index.
4. Turn dial firmly to right (CW) to open lock while pulling door
open.
IMPORTANT: If any combination number is turned past the index,
the entire series of numbers must be redialed starting with 1 above.
To Change Combination Number
1. From the rear of the door and lock, remove the two screws
fastening lock to door. Do not remove the two smaller screws
holding the cover on the rear of the lock.
2. Check that the dial knob is positioned at the proper factory-set
hub number (see above) with the dial “0” aligned with the index.
3. Remove the dial knob and rotate dial to “25” on opposite side of
dial and reinsert dial knob into lock shaft. This will set the dial
knob at a new hub number opposite the previous setting.
4. Reinstall lock to rear of door with the two screws.
5. While looking through the peephole in the back of the lock, turn
dial to the left (CCW) at least four times and stop when the slot
in the first wheel (the one nearest the lock cover) comes in line
with the peephole. Note that there are two slots in the first
wheel. Look for the larger of the two. Read and record the first
dial number at the index.
6. Turn dial slowly to the right (CW) until the second wheel slot
comes in line with the first wheel slot and the peephole. Record
the second dial number at the index.
7. Turn dial slowly to the left (CCW) until the fence in the peephole
drops into the two slots in the first and second wheels. Record
the third dial number at the index.
8. Turn the dial firmly to the right (CW) to open lock. If the lock
does not operate, carefully repeat steps 1 thru 7 above.
CAUTION: Before closing door, test new setting several times.
DO NOT LUBRICATE THIS LOCK.