Salsbury Industries 3400 Series Pedestal Mailboxes ACCESS DOOR COMMERCIAL LOCK - Manual

SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Phone: 1-800-624- 5269 Int’l Phone: 323-846-6700
Fax: 1-800-624- 5299 Int’l Fax: 323-846-6800
www.mailboxes.com engineering @ mailboxes.com
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2013 Salsbury Industries. All rights reserved. (Rev. 01, 8/26/13) Page 1 of 2
ACCESS DOOR COMMERCIAL LOCK
3400 Series Pedestal Mailboxes
Installation Instructions
This installation instruction document is for installing the Commercial lock in the access door on the 3400 series Pedestal Mailboxes.
Note
The mailbox is shipped with a Commercial lock that is not installed in
the access door. This lock is located inside the mailbox on the shelf
of the access compartment.
Installation
Step 1
Open the access door. Remove six (6) preinstalled locknuts and
remove the backup plate, the spacer plate and the door stiffener
bracket. Discard the backup plate as it is not needed.
Step 2
Install the spacer plate against the stiffener bracket aligning its four
(4) holes with the four (4) holes on the stiffener bracket.
Step 3
Install the Commercial lock onto the stiffener bracket by sliding the
lock bolt through the latch slot. Align the four (4) holes of the
Commercial lock with the four (4) holes of the spacer plate and
stiffener bracket.