Salsbury Industries 4325D Designer Roadside Mailboxes In-Ground Mounted Pedestal or Post - Manual

SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Phone: 1-800-624-5269 Int’l Phone: 323-846-6700
Fax: 1-800-624-5299 Int’l Fax: 323-846-6800
www.mailboxes.com engineering @ mailboxes.com
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2011 Salsbury Industries. All rights reserved. (Rev. 01, 11/1/11)
Designer Roadside Mailboxes – 4325D
In-Ground Mounted Pedestal or Post Installation Instructions
U.S.P.S. APPROVED
Installing the In-Ground Mounted Pedestal or Post
When you install a curbside or roadside mailbox, make sure that it is
easily accessible to the mail carrier. By regulation a locked mailbox
should be 41” to 45” from the ground or street surface up to the point
of mail entry. The door should be set back 6” to 8” back from the
front face of the curb or the road edge. However, you should check
with your local postmaster to ensure that the mailbox is installed
according to local regulations. It is important to note that it is not the
responsibility of mail carriers to open mailboxes that are locked,
accept keys for this purpose, or lock mailboxes after delivery of the
mail.
To install the in-ground mounted mailbox pedestal or post, begin by
digging a hole for the concrete footing and then prepare the concrete.
The top surface of the footing should be about 12” by 18”. See the
illustration for the relative position of the rectangular footing to the
pedestal or post and mailbox. The concrete should extend into the
ground 24” or greater if your local frost line is deeper. Installing the
concrete below the frost line will prevent movement during ground
freezing and thawing. The bottom of the hole for the concrete footing
should be filled with a depth of about 6” of gravel to promote
drainage under the post. The top of the footing should be sloped for
water runoff.
When digging the hole for the footing, be careful to not puncture
water, sewer, or gas lines.
After digging the hole, set the pedestal or post in the hole and fill the
hole with the prepared concrete mix. Prod the mix with a stick while
filling to reduce any air pockets. If you want to conceal the concrete,
pour it to within a few inches of the top of the hole and cover with soil
after the concrete has set. Use a carpenter’s level on the sides of
the pedestal or post to ensure that it is aligned vertically. Periodically
check the vertical alignment of the pedestal or post as the concrete is
curing.