Salsbury Industries 4855E Eagle Rural Mailboxes Standard Mailbox Post - Manual (Page 4)

SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Phone: 1-800-624- 5269 Int’l Phone: 323-846-6700
Fax: 1-800-624- 5299 Int’l Fax: 323-846-6800
www.mailboxes.com engineering @ mailboxes.com
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2014 Salsbury Industries. All rights reserved. 1/23/14
Eagle Rural Mailboxes
– 4855E
Deluxe Bridge Style Mailbox Post
Installation Instructions
U.S.P.S. APPROVED
Thank you for selecting Salsbury Industries 4855E eagle rural mailbox. This instruction sheet is for installing the 4855E eagle rural mailbox on a Salsbury deluxe
bridge style mailbox post. A different instruction sheet is available for installing mailboxes on other deluxe mailbox posts. Additional installation instructions are
available for installing the mailboxes on a standard mailbox post or on a decorative mailbox post, installing the mailbox on spreaders, mounting a newspaper holder,
and mounting the post in a concrete footing.
When you install a curbside or roadside mailbox, make sure that it is easily accessible to the mail carrier. By regulation it should be 41” to 45” from the ground or
street surface up to the inside floor of the mailbox. The door should be set back 6” to 8” from the front face of the curb or the road edge. However, you should check
with your local postmaster to ensure that the mailbox is installed according to local regulations.
All hardware required to assemble the mailboxes to the deluxe bridge style mailbox post is provided with the post. Each mailbox requires four (4) 5/16”-18 x 2” long
pan head bolts and four (4) 5/8” nylon spacers to attach to the post arms. The 5/8” nylon spacers are placed between the bottom surface of the mailbox and the top
surface of the post arms. Open the front door of the mailbox and install the four (4) 5/16”-18 x 2” long pan head bolts through the four (4) square holes in the inside
floor of the mailbox, through the four (4) 5/8” nylon spacers (thread onto bolt), and into the four (4) tapped holes in the arm of the deluxe mailbox post. Additional
hardware provided is not needed and may be discarded.
4875 Deluxe Bridge Style Mailbox Post