Salsbury Industries 4800 Series Decorative Mailbox Posts - Manual

SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Phone: 1-800-624-5269 Int’l Phone: 323-846-6700
Fax: 1-800-624-5299 Int’l Fax: 323-846-6800
www.mailboxes.com engineering @ mailboxes.com
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2011 Salsbury Industries. All rights reserved. (Rev. 01, 11/1/11)
Decorative Mailbox Posts – 4800 Series
Decorative Arm Post Installation Instructions
Installing Arm on a Decorative Mailbox Post
Thank you for selecting Salsbury’s 4800 series decorative mailbox post. We are confident that the quality and construction of the post will prove to
be a good investment.
This assembly instruction is for the decorative mailbox post only,
including models 4825, 4835, and 4845.
See the installation instructions for the mailbox to install the mailbox
on the post. The hardware kit for mounting the mailbox is included
with this post.
The decorative mailbox post should be mounted on a concrete pad
or in the ground before proceeding with assembly of the top plate
and arm. See separate instructions for the post mounting process.
The top plate and arm must be assembled to the post as shown in
the illustration. Install two (2) 5/16”-18 x 1” long hex flange head
bolts through the two holes in the rear flange of the top plate into the
upper two tapped holes in the decorative post. Leave the bolts
loose.
Position the arm so that the two studs in the front of the top plate
protrude through the holes in the front of the arm. Install two (2)
5/16”-18 x 1” long hex flange head bolts through the two (2) holes in
the rear flange of the arm into the lower two (2) tapped holes in the
decorative post. Also leave these bolts loose.
Install two (2) 1/4” split washers and two (2) 1/4”–20 nuts on the
studs at the front of the top plate after ensuring that the two (2) studs
are aligned through the holes in the front of the arm.
Securely tighten the four (4) hex flange head bolts and the two (2)
hex nuts. Attach the appropriate plastic cover caps to the four (4)
hex flange head bolts and the two (2) nuts. Additional hardware
provided is not needed and may be discarded.
The mailbox may now be installed to the post.