SATEC AX-8 - Manual (Page 6)

3
2 Field Setting
2.
2.1 Default Setting
The Analog Expander is set by the dip switches S1 and S2 on the PCB
located inside the AX-8 case. The default setting is as follows:
Expander address 0 1
Analog output range factory set as per order
Protocol ASCII
Data format 8N (8 bit, no parity)
Baud rate 9600 bps
If you require a change to this setting, open the case as per Sections 2.2 -
2.4 below and change the setting.
2.2 Changing the Communication Parameters
(Firmware Version 0.10)
1. Disassemble the AX-8 case: remove the 8 screws from the
outside of the case and take off the rear cover.
2. Set the DIP switches on the PCB (see Figure 2-1) as shown in
Tables 2-1 and 2-2 below.
3. Re-assemble the case: put the rear cover back on, insert and
tighten the 8 screws.
1 This address allows use of up to 7 or 8 analog outputs, according to the analog
output setup in the Powermeter. Use of additional outputs from one Powermeter
requires installation of an additional AX-8 unit with address ‘1’.