Schroth Racing HYBRID Restraints - Manual

Operation Instructions for HYBRID Restraints
Figure IV Figure V Figure VI 990143
2
0
0
2
-1
2
-1
0
· Extend both shoulder belts by lifting up on the Length Adjuster and pulling up.
· Extend the lap belts:
· Lap belts can be extended by lifting up on the Length Adjuster and pulling away from the centre of your lap
· Fixed belts (without adjusters) must be pre-installed to fit tight within the crest of the pelvic bone.
· Attach the crotch straps and lap belts:
· Slide the left side crotch strap loop over the left side lap belt latch and click it into the Cam Lock (Rotary Buckle) on the
left side. (Note: Pull Tabs should be facing up with )
· Slide the right side crotch strap loop over the right side lap belt latch and click it into the Cam Lock on the right side.
RED Tab on RIGHT side of belt.
Figure II
· Attach the second shoulder strap to the Cam Lock.
· Tighten lap belt as tight as possible (if an adjuster is available) before tightening shoulder belts. Be sure that the Cam Lock is
centred.
· Tighten shoulder belts (Figure V). Make sure strap tightening results in a Cam Lock and lap belt position as shown in Figure VI.
· If position is not as shown in Figure VI, extend the shoulder belts and re-do lap and crotch strap adjustments to achieve the
proper belt geometry.
NOTE: When inserting the lap belt latch into the Cam Lock be sure that the raised end of the latch is facing away
from the body as shown in Figure III.
NOTE: Pre-adjusted crotch strap length should position buckle as shown in Figure IV.
Þ Deutsche Version siehe Rückseite!
Figure I
Pull Tabs for crotch straps can be
used to pull loops over lap belt
latches.
(Red Tab is for RIGHT side)
Pull Tabs should be on top of the
belts
Latches inserted with
raised end up [see Figure III]
extended
shoulder belt
length adjuster
45° angle
Figure III