Schroth Racing QuickFit And QuickFit Pro VW/Audi/Seat/Skoda (VW-A-S-S) - Manual (Page 5)

7
Use of improper attachment points will impair system
performance.
Weak tail strap anchor points will not withstand the forces in an
accident and increase the risk of personal injury.
Never attach the tail strap to anchorages intended for the tether
straps of child seats that are found on the filler panels behind the
rear seats of some passenger cars or the luggage area of some
hatchbacks or station wagons. These anchor points are not strong
enough to withstand the forces of an accident and are not
intended for adult belts.
Harness belt systems may only be installed at suitable anchor
points for seat belt systems as originally installed by the vehicle
manufacturer.
For suitable anchor points for make, model and model year of
your vehicle, see Certified Vehicle List (Vehicle Reference List). If
in doubt, ask your dealer to show you where these anchor points
are located.
These figures show the general location and suitability of seat
belt anchor points installed as standard equipment in specific
VW-A-S-S model passenger cars.
Diagram applies to the VW-A-S-S approved models
▀ Green squares represent points where SCHROTH provided
male connecting tail straps are to be installed at factory
mounting points along with factory provided harnessbelts.
● Red Circles represent points where the SCHROTH
VW-A-S-S QuickFit ® belts are designed to plug into
VW-A-S-S factory provided seatbelt female receptacles.
THIS SCHROTH VW-A-S-S QuickFit
®
HARNESSBELT IS ONLY DESIGNED FOR
VW-A-S-S MODELS AS INDICATED ON THE
SEWN IN LABEL ON THE HARNESSBELT
TAILSTRAP. USE IN ANY OTHER MODEL OR
IN ANY OTHER AUTO OF A DIFFERENT
MANUFACTURER COULD RESULT IN THE
FAILURE OF THE HARNESS SYSTEM AND
SERIOUS INJURY.
Never drill or tap or make a new attachment point in the body or
chassis in order to mount a SCHROTH harness at that location.
Such attachment points are inadequate, may be improperly
located and can seriously impair the function and effectiveness
of the system.
Please compare the mounting locations on your car with the
illustration on page 6 and verify the “Model Tag” as pictured
above (sewn into the tail strap) matches the model of your
vehicle.
Original equipment belts with swivel attachments must never
be bent, modified, impeded or restricted in their range of
motion.
2 Anchorage bolts & SCHROTH Rallye bolt on bracket
Where additional SCHROTH connecting tails are to be
installed (referenced by the Green squares on the diagrams on
page 6), the SCHROTH connector will be bolted to the a
factory mounting point along with the factory belt using the
factory provided bolts. You should be able to tighten each bolt
a minimum of nine (9) full 360 degree turns. Tighten all
anchorage bolts to a torque of 30 ft.lbs. (40 Nm)
3
Installation of SCHROTH rear outside tail strap
buckles – Left & Right belts.
Remove the rear seat bottom cushion. It will pull
straight up and release with moderate force.
Locate and remove the outermost VW-A-S-S lap belt
anchor bolts at the outside corners just below the rear
seatback bolsters.
Bend and mount the SCHROTH tail strap connector
as shown in the picture above.
Do Not re-install the seat cushion until completing the
rest of the installation.
6