Remember, For safety’s sake, always buckle up, Mdi inc – Schroth Racing AutoControl III User Manual
Page 17
17
4 Accident
A safety belt which was in use during an accident has
been weakened and is unfit for further use and must be
replaced!
• One indication that the belt was exposed to excess strain
and therefore requires replacement is when the stitches of
the asm-system are ripped open and are protruding from
underneath the asm-plastic cover.
A restitched asm seam is dangerous.
The asm energy conversion device may not be restitched
under any circumstances.
After an accident, in addition to replacing seat belt which were
in use, also be sure to ask your car dealer for carefully check
all seatbelt attachment points for deformation or cracks.
Always make sure that the guidelines of the car manufacturer
are followed if a repair is necessary.
5 Cleaning
To clean the belt, use soap and warm water. Do not use any
solvents! Do not dry the belt in the sun or near a radiator.
Improper cleaning or drying of the harness belts can
weaken them, reduce their effectiveness and can result in
serious personal injury or death.
Schroth reserves the right to incorporate any technical
changes or further development in this product without
notice.
If you need additional information or have any comments
or questions about the SCHROTH asm harnessbelts,
please contact your dealer or the importer.
[see www.schroth.com]
In North America please contact:
MDI Inc.
9A Electronics Ave
Danvers, MA 01923
Toll Free (888) 536-8550
Phone (978) 532-1145
Fax (978)
532-2016
REMEMBER:
For safety’s sake, always buckle up.
SCHROTH and SCHROTH-asm
®
are registered trademarks of
SCHROTH Safety Products GmbH, Germany.
The SCHROTH-asm
®
safety system is patented in several European
countries, the United States and Japan.
The copyrights of this Installation and Operating manual are
property of SCHROTH Safety Products GmbH, Germany.
Copyright of this part or in hole, on paper, on film or
electronically is allowed only after written permission by
SCHROTH Safety Products GmbH, Germany.
© 2002, SCHROTH Safety Products GmbH, Arnsberg, Germany.
Printed in USA