Assembly instructions – Schwank 4002J Portable Patio Heater User Manual
Page 9
4001/2-J, 4N11/2-J Manual
IM061103
RD: Aug 2006
R.L. 08B
KH
5. ASSEMBLY INSTRUCTIONS
Fasten the post to the top of the post
brackets, aligning pre-drilled holes as
shown.
Use six M6 x 35mm bolts, washers &
nuts to attach post to post brackets.
Tighten securely
.
Page 8
Attach Wheel Kit to base:
Assemble wheel brackets to base ‘L’ brackets using four #8 x
3/4” bolts and nuts (Note: Bolt heads face the wheel; Position
wheel brackets with curve “up”)
Align pairs of holes in each end of ‘L’ brackets to those in
opposite sides of the base - fasten in place with #8 x 3/4”
bolts & nuts. (NOTE: Position wheel brackets with curve “up”)
Assemble wheels to wheel brackets using axle bolts & nuts
NG Model Only: Install #10 x 1 1/4” bolt up though the hole in
top of cylinder base - opposite the wheel assemblies
Place washer on bolt
Insert up through hole in top surface of base
Fasten with washer and nut
Finger tighten the second nut in place for later use
Wheel brackets curve ‘up’
Attach the 3 post mounting brackets to the
Cylinder Base as shown.
Use three M8 x 15mm bolts to secure
brackets to the base