SDC LRSG1R REQUEST-TO-EXIT ELR SWITCH KIT SARGENT - Manual

INSTALLATION INSTRUCTIONS LRSG1R
REQUEST-TO-EXIT ELR SWITCH KIT
SARGENT
P:\INSTALLATION INST\SWITCH KIT\INST-LRSG1R.vsd REV B 03-13 Page 1
Any suggestions or comments to this instruction or
product are welcome. Please contact us through
our website or email [email protected]
801 Avenida Acaso, Camarillo, Ca. 93012 • (805) 494-0622 •
www.sdcsecurity.com • E-mail: [email protected]
Attach the REX switch bracket to the ELR unit with the supplied screws. Attach ELR/REX assembly to
linkage (refer to ELR Installation Instructions). Insert REX switch assembly into device under the
linkage. Depress the Push Bar to raise the pivot arm. Slide the ELR and REX assembly under the
pivot arm and secure in place by attaching the ELR to the Device base with the supplied screw (refer
to ELR Installation Instructions). Release Push Bar and make sure the pivot arm is properly
depressing the switch arm.
Linkage
Push Bar
Pivot Arm
Secure unit in place with supplied screw.
COM WHITE
N/O RED
N/C GREEN
Attach REX
to ELR