SDC E300 SERIES MAGNETIC LOCK - Manual (Page 2)

P:\INSTALLATION INST\Electromagnetic Locks\EXCEL\INST-E300.vsd REV - 07-10 Page 2
1. Inspect the frame header to determine if mounting accessories are required (refer to page 4).
2. Fold template as indicated on dotted line. For single doors locate template against the door and header on the
lock jamb side of the frame.
3. Mark and drill holes as indicated by the template.
4. Mount armature to door.
STEP 4
5. Install mounting plate to header with the interlock detail away from the door side of the stop.
Loosely fasten screws through adjustment slot as shown. Assure that the mounting plate and
armature line up properly, then tighten down ALL mounting screws.
STEPS 2 & 3
STEP 5