SDC MSB550 MECHANICAL SWITCH BAR - Manual (Page 3)

SECURITY DOOR CONTROLS
801 Avenida Acaso, Camarillo, CA 93012 • (805) 494-0622 • Fax: (805) 494-8861
www.sdcsecurity.com • E-mail: [email protected]
O:\INS\INST-SW BAR-GLASS
Attach bar mounting brackets
to glass mounting base.
Secure glass mounting base assembly to each end
of bar assembly. Secure plastic end caps to bar. Do
not tighten all the way. (Loose fit during application
will allow mounting blocks to be placed flat against
the glass. Once mounting blocks adhere to glass,
tighten screws completely after connecting power
leads to device).
Using tape mark bar
location on outside of
glass door.
Tape
CLEAN
USING
ALCOHOL
SWABS
Clean glass and mounting
blocks with alcohol swabs
provided.
Apply hardener primer to glass and blocks
wait 3-5 minutes and apply adhesive to
blocks only.
Press and hold bar firmly
in place against the glass
door for approximately 3
minutes until bar is secure
to door.
Step 1 Step 2
Step 3 Step 4
Step 5
Step 6
500GL - KIT
GLASS MOUNT INSTALLATION
MSB550/PSB560