BIXOLON label printer SRP-770II - Manual (Page 22)

Rev. 1.14 - 22 -
SRP-770II
5-7 Auto Cutter (option)
Auto cutter should be used for continuous paper only. ( i.e. roll paper)
1. Open the Dip switch cover, and make the switch 1 number 7 “On”.
(Refer to printer mode setting at Chapter 5-1.)
2. Put a paper roll into the printer and close the cover.
SAM
SU
NG
LAB
EL
PR
NTE
R
※ CAUTION (Partial cut)
Once the printer cut the paper, remove the receipt in order for next printing.
Otherwise the receipt could be back into the printer and the cutter would cut it again.