Simpson SEAT BELT User Manual
Page 6
www.simpsonraceproducts.com
6
1-800-731-4404
Version 1
Double Anchor Pinch Clamp:
The double anchor pinch clamp is mostly used in the 6-point mounts.
Make sure to bolt the anchors down against a flat surface with the webbing coming off the anchors under the
anchors.
Figure 4f: Side Profile of 2-
bar adjuster.
Figure 4e: Pull the excess
webbing through the anchor
and adjuster to tighten and
lock down.
Figure 4d: The free end of the
webbing then routes through
the 2-bar in the middle of the
two pieces of webbing already
there.
Figure 5d: The anchor should
then be mounted against a flat
surface with the webbing
routing under the anchors.
Figure 5b: Bring the free end
of the webbing back through
ONE of the anchors.
Figure 5a: Initial Lacing of the
two anchors. Lace the
webbing through both tongues.
Figure 4g: The 2-bar adjuster
may also be used around a bar
in the same manner.
Figure 5c: Tighten the belt
around the anchors at the
desired length.