Skyjacker MS968 - Manual (Page 2)

7. Install the new lower bracket on top of the factory upper A-
Arm. The two outside bolts will line up with factory holes in
the upper A-Arm. Attach the bracket at these points using the
6 x 30mm bolts and washers. With the outer bolts installed,
mark and drill the two inner holes using a 13/32” drill bit.
Once drilled install bottom plate on the bottom of upper A-
Arm. Attach to upper bracket using the 3/8 x 2 3/4” bolts,
washers, and lock nuts. (See Photo #6).
8. With all brackets installed, install the new shocks using the
1/2 x 3” fine thread bolts, washers, and nuts.
9. After installation, reinstall front tires and lower vehicle onto
the ground. Cycle the steering left to right and check tires and wheels for clearance.
Photo #6
• After installation is complete, double check that all nuts
and bolts are tight.
• Check all wiring and hoses for proper clearance.
• Retorque all bolts after the first 100 miles.
Seat Belts Save Lives, Please Wear Your Seat Belt.
Pg 2