Skyjacker TU761PRS User Manual
Skyjacker For the car
2007 - 2012 Toyota Tundra
6” Suspension Lift
Installation Instructions
RequIRed TooL LIST:
* Safety Glasses
* Metric / Standard Wrenches & Sockets
* Allen Wrenches
* Assorted drill Bits
* Floor Jack
* Jack Stands
* Measuring Tape
* Torque Wrench
* Reciprocating Saw (4Wd Models)
* Grinder (4Wd Models)
* Welding Machine (4Wd Models)
www.skyjacker.com
I-TU761 REV5 7-12
Pg 1
Before beginning the installation, thoroughly & completely read these instructions & the enclosed
driver’s WARNING NOTICE. Affix the WARNING decal in the passenger compartment in clear view
of all occupants. Refer to the Parts List to insure that all parts & hardware are received prior to the
disassembly of the vehicle. If any parts are found to be missing, contact SKYJACKER® Customer
Service at 318-388-0816 to obtain the needed items. If you have any questions or reservations
about installing this lift kit, contact SKYJACKER® Technical Assistance at 318-388-0816.
Make sure you park the vehicle on a level concrete or asphalt surface. Many times a vehicle is not
level (side-to-side) from the factory & is usually not noticed until a lift kit has been installed which
makes the difference more visible. Using a measuring tape, measure the front & rear (both sides)
from the ground up to the center of the fender opening above the axle. Record this information
below for future reference.
Driver Side Front:
Passenger Side Front:
Driver Side Rear:
Passenger Side Rear:
IMPoRTANT NoTeS:
• OEM wheels can not be reused in the installation of this suspension lift. 17" diameter or larger
wheels must be used to install this suspension lift.
• This lift is determined from the amount of lift to the front of the vehicle, while only lifting the rear to
a position level with the front.
• If larger tires (10% more than the stock diameter) are installed, speedometer recalibration will be
necessary. Contact your local Toyota dealer or an authorized dealer for details.
• After installation, a qualified alignment facility is required to align the vehicle to the OEM
specifications.