Skyjacker L40KS - Manual

1964-1980 FJ40 LandCruiser 4WD
Installation Instructions
Part # L20KS & L40KS
I-TL 7-03 Pg 1
Before beginning the installation, read these instructions and the enclosed driver’s WARNING
NOTICE thoroughly and completely. Also affix the WARNING decal in passenger compartment in
clear view of all occupants. If any of these items are missing from this instruction packet, do not pro-
ceed with installation, but call SKYJACKER® to obtain needed items. If you have any questions or
reservations about installing this lift kit, call SKYJACKER® at 318-388-0816 for Technical Assistance
or Customer Service departments.
Make sure you park the vehicle on a level concrete or asphalt surface. Many times a vehicle is un
level (side-to-side) from the factory, but usually not noticed until a lift kit has been installed which
makes the difference more visible. Using a measuring tape, measure the front and rear (both sides)
from the ground up to the center of the fender opening above the axle. Record below for future ref-
erence.
Driver Side Front: Passenger Side Front:
Driver Side Rear: Passenger Side Rear:
IMPORTANT NOTES:
• Please refer to Parts List to insure that all parts and hardware are received prior to disassembly of
vehicle. If any parts are found to be missing, contact your dealer as soon as possible.
• After installation occurs, a qualified alignment facility is required to align the vehicle to factory
specs.
REQUIRED TOOL LIST:
* Metric and Standard wrenches and sockets
* Floor Jack
* Jack Stands
* Measuring Tape
* Torque Wrench
Note: 2” Lifts require 2 Front springs Part # L20FS, 2 Rear Springs Part # L20RS
Note: 4” Lifts require 2 Front springs Part # L40FS, 2 Rear Springs Part # L40RS
Contents: Box Kit Part # L24S
Part # Description Qty
916X314X712U 9/16 X 3 1/4 X 7 1/2 U-BOLT 7
916X314X912U 9/16 X 3 1/4 X 9 1/2 U-BOLT 1
SP2032 TOY LANDCRUISER SPRING BUSHING 16
916FTN 9/16-18 NYLON INSERT LOCKNUT
16