Skyjacker 7220 - Manual

Installation:
1. Park the vehicle on flat level ground & set the emergency brake.
2. Turn the tires / wheels to a straight forward position.
3. Install the new Skyjacker shock boots over the new Skyjacker steering stabilizers & secure with
the supplied boot ties.
4. Install the new Skyjacker axle bracket on top of the axle using the supplied 3/8" x 3 1/8" x 3 1/2"
u-bolts, washers, & nuts.
5. Attach the two straight studs to the new axle bracket & mount one end of the new steering
stabilizers to each stud & tighten. Note: The cylinders may be mounted with shaft end to the tie
rod end bracket if preferred.
6. Pull the steering stabilizers out 4 3 /
4
" out (exactly halfway). Note: The center to center eye length
will be 19" when the steering stabilizers are halfway out.
7. Install the new studs into each eye of the new steering stabilizers & tie rod brackets.
8. Mount the new Skyjacker tie rod
end brackets using the supplied
5/16" x 1 1/4" x 1 3/4" u-bolts,
washers, & nuts.
9. Cycle the tires / wheels fully to
the left & right to make sure the
new steering stabilizers are
adjusted properly & that all
brackets are secure.
SEAT BELTS SAVE LIVES, PLEASE WEAR YOUR SEAT BELT.
Pg 1 I-7220 REV1 3-11
GMC, Ford, Dodge
Dual Steering Stabilizer
Part # 7220
Contents:
2 - 7000WS Steering Stabilizers
2 - Boots & Boot Ties
4 - 140629 Straight Studs
1 - Large Axle Bracket
2 - Axle Bracket U-Bolts w/Nuts & Washers
2 - Straight Tie Rod End Brackets
4 - Tie Rod End U-Bolts w/Nuts & Washers
www.skyjacker.com