Skyjacker 7217 - Manual

#7217 Steering Stabilizer
INSTALLATION INSTRUCTIONS
#I-7217 (Rev. 1/02)
ITEM PART # DESCRIPTION QTY.
7000WS STEERING DAMPER, WHITE 2
B10R RED BOOT 2
BTIE BOOT TIE STRAP 2
7217-MB MAIN BRACKET FOR FRAME 1
7217-FP FLAT PLATE BRACKET FOR DRAG LINK 1
HB-7217W HARDWARE BAG: 1
CONSISTING OF:
12X212FTB
1/2 X 2 1 ⁄
2
” FINE THREAD BOLT 1
12X3FTB 1/2 X 3” FINE THREAD BOLT 2
12X4FTB 1/2 X 4” FINE THREAD BOLT 1
12FTN 1/2” FINE THREAD NUT 4
12SAEW 1/2” SAE WASHER (SMALL WASHER) 6
12USSW 1/2” USS WASHER (LARGE WASHER) 4
516X114X134 5/16 X 1 1 ⁄
4
X 1 3 ⁄
4
” U-BOLT, ROUND 1
516SAEW 5/16” SAE WASHER 2
516FTN 5/16” FINE THREAD NUT 2
54314 141509 STEEL SLEEVE 2
81004 TAPERED SLEEVE 1
P932 140629 STABILIZER STUD PAK 2
HOURGLASS 5/8 SHOCK EVE BUSHING 4
PARTS BREAKDOWN
NOTES: Refer to PHOTO #1 during installation. The photo shows an application
with SKYJACKER’s ® 5” suspension system using a drop pitman arm (drag link is
installed to the bottom of pitman arm); however, this dual steering stabilizer kit will also
work with the original pitman arm, and a lift kit is not required.
1. To install new dual steering stabilizer insert
a poly bushing into each eye of both
stabilizers, and insert a steel sleeve only in
the eyes connected to the body (not on the
end of the shaft). Position poly boot onto
stabilizers and secure with tie straps
provided.
2. Remove original steering damper from
vehicle. Install main bracket to original frame
mount on passenger side by inserting a
1 ⁄
2
” X 3” bolt with a small 1 ⁄
2
” washer through
original mount, new bracket and stabilizer
using another small
1 ⁄
2
” washer with self-
locking nut and tighten.
Application: 94-97 4WD Dodge Ram
PHOTO #1
1.